0
Add your answer:
Earn +20 pts
Why is a car jack called a jack?
It is called a "jack" because it takes the place of a man.
What car part starts with the letter J?
jack
What is a car part that starts with letter J?
JACK
Where do you place a car jack on a 1995 Honda Accord?
where to place car jacks on 1995 honda accord lx
A part of a car that starts with the letter j?
jack
Where do I place the jack to jack up the front of a 1994 Chevy cavalier?
It is easier to just jack up both sides of the car separately, or drive the car up on ramps.
Where do you place the car jack on an f 250?
anywhere on the frame rails
Where do you place jackstands on impalas while lifting the car?
The safest place to place jack stands are under the frame. You need to jack the car high enough to keep the tires off the ground especially if you plan on working on the breaks or axles. Keep them away from the car WHILE lifting but place under the FRAME once the car is elevated.
Where to place the jack to drain out oil from a car?
place jack on frame or jack slant behind front tires. Better yet, purchase a pair of ramps and drive the vehicle up on them.
How do to Jack up a 1998 Corvette?
The owner's manual will show you the points to place the jack. I suggest a floor jack and jack stands if you will be climbing under the car.
Where do you place the jack on 1994 Toyota Camry with a rear flat tire?
Underneath each door there are two notches on what looks like the siding, but is actually part of the frame of the car. Assuming you have a scissor jack, you would place it right where the notches are. There are four spots total with notches.
How do you change transmission filter on a 2003 alero?
Get a jack two jack stands, jack the front of the car up and place the two jack stands under the car, then go to where the transmission is and take the bolt off, then there should be a filter that says transmission filter, the one that says transmission filter will tell you both what part of car you're draining the fluid from and the filter you are taking off. Transmission filters are generally smaller than oil filters. The bolt that you take out should be very close or on the other side touching the same part of the car. Then plug it up when its done draining then jack the car up, take the jack stands off and jack it down. Finally, open the hood and replace the transmission fluid.
