The GMA series of fuse is a fast acting glass tube fuse. The dimensions are 5 X 20 mm. This series of fuse's amperage span is from 63 mA right up to 8 amps. I would suggest that your fuse is rated at 250 mA or (1/4 of an amp) with a 250 volt rating.
No
nope
It should be the same thing. But other things are also described as T100L so you should make sure it's a fuse and check by holding it up to the light that it has a very thin wire inside the glass tube.
The current rating is 2A (2 amps).
yes. the 250v just means that's the maximum voltage rating the fuse can handle .. so it can def handle 125v. just not vice versa.
The amperage of a T2L 250v fuse is typically 8 amps. It is a misconception that it has an amperage of 3.
No, it is not recommended to replace a 250V 3.15A fuse with a 250V 2.5A fuse. The replacement fuse should have the same voltage rating, but the amperage rating needs to be equal to or higher than the original fuse to ensure proper protection against overcurrent.
The letters in T6.3AL250V typically refer to the electrical characteristics of a fuse. T indicates it is a time-delay (slow-blow) fuse. 6.3A specifies the current rating, meaning the fuse will blow if the current exceeds 6.3 amps. 250V indicates the maximum voltage the fuse is designed to protect against.
The "L" in T2AL stands for "Low breaking capacity." This indicates that the fuse has a lower interrupting rating compared to other types of fuses.
yes it can but it may not protect as well the f5L is a fast blow fuse made to react quickly to the overcurent
T= timedelay 800= ? L=? 250V= volts