theres no dipstick on a yammaha yz, theres a clear glass sight when the bike is level the oil should be visible in the sight glass!! careful not to overfill above the glass, if you do let some out till you can visibly see the oil level!
It depends on what kind of equipment/engine. On my shop air compressor the oil level should be at the midpoint of the sight glass.
there should be a sight glass on the right side of the motor
There is a sight glass on the side of the engine. With the bike sitting level, the oil should be between the two marks on the engine case beside the sight glass.
There is a sight gless on the left side of the motor crankcase. Stand the bike up level and hav a friend view the oil level in the sight glass. It should fill the sightglass to th3e halfway point,
There should be a sight glass on the left lower side of the motor. The oil should be visable in the glass.
Actually there is no dipstick, there is a sight glass on the left lower side of motor with 2 marks on the case . The upper mark is the full level. You can see the oil thru the round glass sight glass
there is a site glass on right side of engine about mid ways of brake petal Where should the oil leve be in the site glass when the oil level is full?
There is a sight glass on the right hand side. The bike needs to be level (either held level by someone else, or on the center stand), and the oil level shuld be at the center (shown by a dot) or slightly above. It should not be empty or full to the top. There is a sight glass on the right hand side. The bike needs to be level (either held level by someone else, or on the center stand), and the oil level shuld be at the center (shown by a dot) or slightly above. It should not be empty or full to the top.
I have an '83 so they should be the same. Look towards the bottom of the engine on the right side between the peg and the brake. there should be a sight glass on the block with a small peg that has a slot in it sticking out of the middle of it. after cleaning the outside of the glass if you still can't see the level due to the glass being dirty on the inside, get a flat head screwdriver and turn the peg in the middle of the glass in a complete circle several times. This is a cleaner and should clarify the inside of the sight glass. now you should be able to view the oil level, but make sure you put it on the center stand first.
The proper procedure for checking the oil level is to look in the oil sight glass with the bike sitting level. If you see all oil and no air bubble at the top then you have sufficient oil.
Some units have a sight glass. You should see the oil level in this site glass. Some are full if you see 1/4 level and some are full if you see 1/2 level. I suggest you take it to a professional. Oil level is critical. Units hold from 5 ounces to 11 ounces. Knowing exactly how much to use is imperative.