it goes to the purge valve in the back of your motor.
Pull upward on the hose that the PCV valve is in. The PCV valve will pull out of the hose. The PCV valve is located in the valve cover.
where is pcv hose on a 1997 ford exploer Eddie Bauer
PCV hose. Any quality neoprene hose that has similar dimensions will work.
The PCV hose is on the side of the engine towards the front of the vehicle. It is on the drivers side behind the header.
The pcv hose is connected to the Pcv valve and the intake manifold. the pcv valve is circular metal piece on the top of the engine cover. Just replace with any rubber hose with similar thickness and heat resistance. You may use same ring clamps if necessary
The PCV valve is on top of the valve cover. Should be a hose connected to it.
PCV valve should be on bottom right side of motor. to the right of the last spark plug. Pull it out with car off. It comes out with a hose on it. Insert new PCV valve into hose. Insert PCV into open hole.
the pcv is in the back center of the plenium (intake) has a hose on it that goes to the left valve cover the pcv is in the back center of the plenium (intake) has a hose on it that goes to the left valve cover
Remove the PCV valve retaining screws. Remove the PCV valve hose. Reverse the process to install the new PCV valve.
I have a 2004, colorado, and it dont have a pcv valve, just a hose from the crank to the resonator.
pcv is located on the engine valve cover will have a black rubber hose attached to it