answersLogoWhite

0


Best Answer

1 3 4 2 clockwise from bottom left

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the order to plug the spark plug wires into the distributor cap on a 1991 acura integra?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How to check a distributor on 94 Acura Integra?

no spark


Where is a distributor located in a 1995 Acura Integra?

1995 Acura Integra probably doesn't have a distributor, it would have coil packs, follow your spark plug wires from the spark plugs back. where the spark plug wires stop that's what has taken the place of your distributor. Its computer controlled the computer is probably under the dash on the passenger side of the car


How do you replace an Acura Integra distributor?

Unplug all the spark plug wires. then loosen the screws holding the distributor on, remove it, put the new one on and screw it in, then replace the spark plug wires


What is spark plug torque Acura Integra 1998?

From the Haynes Acura Integra Repair Manual, 156 in-lbs.


What is Spark plug gap for 1986 Acura Integra?

0.041 (in)


What is the spark plug gap on a 1996 Acura Integra rs?

.44


Spark plug gap for a 1994 acura integra LS?

.044


1991 acura integra LS will not start I've already checked for spark replaced fuel filter as well as distributor cap and rotor what can be wrong with it?

timing belt probley comon thing


What is the correct placement of distributor wires from the spark plug to the distributor cap on a 1992 Acura Vigor?

123c54


Why does your 1998 Acura Integra crank but not start?

could not be getting spark our gas our timing belt no good


How many spark plugs needed to be replaced in an 98 acura integra?

4, four, quatro, apat..


How do you change the distributor in a 1994 Acura Integra LS?

for change of distributorYou need to remove three bolts that hold it in when removing map out the exact location of the prongs to the distributor which come out of the engine. When the new on goes in make sure it exactly the same way the old one was...note don't forget to write down in which order the spark plug wires are plugged