answersLogoWhite

0


Best Answer

The firing order should be 1-5-3-6-2-4.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the firing order for a 4.0 6 cylinder engine?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is a Yamaha 40he 6h4l?

40 hp 3 cylinder outboard engine


What is the firing order for a 1998 350 short block Chevy engine?

1 8 4 3 6 5 7 2 the same one they've been using for 40 years.


What is the head torque setting for 74 hilux 12r engine?

The cylinder head bolt torque specification is 160 pounds. The cylinder head bolts should be torqued in 40 pound intervals.


Kawasaki kx 125?

The Kawasaki Kx125 is a model of Kawasaki motorcycles. It has a six gear transmission and a single cylinder, 40 horsepower engine.


How does a CO2 gun work?

When the C02 cylinder is placed into the gun and screwed in the end of the cylinder is pierced and some C02 charges the system of the pistol. When the trigger is pulled a burst of the C02 gas is released behind the pellet, firing it down the barrel. You can usually get about 40 to 50 shots from as regular 12 oz C02 cylinder.


What is the correct ignition timing for a 1996 ford escort - 4-cylinder engine?

The timing for a 1996 ford escort 4 cylinder engine should be 6 degrees BTDC. If it's a CVH model, 12 degrees. If it's on a distributorless engine or programmed ignition system, it can't be adjusted. Contact breaker distance should be (on a bosch distributor) .40 to .50 mm. On a Lucas distributor, .40 to .49 mm.


2002 stock Ford Escape battery?

The 2002 Ford Escape owners manual shows : For the 4 cylinder engine ( Motorcraft BXT - 96R battery ) For the V6 engine ( Motorcraft BXT - 40R battery ) www . motorcraft . com ( no spaces ) only shows batteries for the V6 engine ( BXT - 40 R / BXL - 40 R / BXS - 40 R )


What is torque on the head bolts 2002 Cavalier 2.2?

The 2002 Cavalier 2.2 liter engine cylinder head bolt torque specification is 120 pounds. The cylinder head bolts should be torqued in 40 pound intervals.


Is 10W40 to thick of an oil to put in a four cylinder engine?

The majority of 4 cylinders use a good 10W 40 Motor oil. No It Will Do Just Fine With 10W40


How do you un-freeze a jet ski engine?

pull the head off, soak it with wd-40 and then let it sit over night. get a piece of wood that will fit in the cylinder, like a 2x2 then hit it with a hammer. if the pistons are seized, then the motor is probably junk. order a new one.


Torque specifications for cylinder head 2003 kia Rio 1.6L?

The torque specifications for the cylinder had, in your 2003 Kia 1.6 liter engine, is 120 pounds per square inch. The bolts should be torqued at 40 pound intervals.


What are the torque spec for the head for 2001 Chevy cavalier 2.2?

The 2001 Chevy Cavalier 2.2 liter engine cylinder head bolt?ætorque specification is 120 pounds. The cylinder head bolts should be torqued in 40 pound intervals.