0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the oil pressure regulator on a ford f350 diesel truck?
where does the oil pressure regulator on a ford f350 diesel truck
Location of oil pressure switch on a 2001 expedition?
Are you referring to the (oil pressure sensor) or the (oil pressure regulator)?
Does a Jeep Wranglers have an oil pressure regulator?
Yes, it is part of the oil pump.
94 z28 Camero with low oil pressure The manual says it may be a oil pressure regurator Where is the oil pressure regulator?
May be on top of the oil filter
How can fuel get in the engine oil?
The pressure regulator is defective or an injector is stuck open.
Why would your oil pressure read high?
bad sending unit, or bad regulator.
Where is a fuel pressure regulator on a alero?
The regulator is on the right said if its a 4 liter engine. In front of the oil cap it has thin wire under it
What determines the maximum oil pressure in a force feed lubrication as the engine speed increases?
Oil pumps have a spring operated regulator and the spring's tension determines the max oil pressure.
Where is the fuel pressure regulator in a 1995 ford explorer?
Looking from the front , I believe the fuel pressure regulator on your 4.0 L OHV engine is about 2 inches to the right of your oil fill cap on top of the engine
Why would gas be in the oil in 4.3 Chevy engine?
CFI ? The fuel pressure regulator could be leaking.
Where is the fuel pressure regulator sensor on a 03 f250 diesel?
The fuel pressure regulator is underneath the fuel filter bowl on the righthand side of the motor. It has a two wire connector plug that goes into it. Also it is underneath the oil pressure sensor switch.
How do you remove a fuel pressure regulator on a 2005 ford expedition Eddie Bauer?
Fuel Pressure Regulator is located on the fuel rail.Fuel Pressure Regulator 1. Disconnect the negative battery cable. 2. Properly relieve the fuel system pressure. 3. Remove the air cleaner outlet tube(s). 4. Remove any necessary components to access the pressure regulator. 5. Disconnect the vacuum hose from the pressure regulator. 6. Remove the pressure regulator attaching screws. 7. Remove the pressure regulator from the fuel rail. To Install 8. Discard the O-rings on the pressure regulator and replace them with new ones. 9. Lubricate the O-rings with clean engine oil. 10. Install the regulator into the fuel rail and tighten the retaining screws. 11. Connect the vacuum hose to the regulator. 12. Install any components removed to access the regulator. 13. Install the air cleaner outlet tube(s). 14. Connect the negative battery cable.
