Not all Subaru engines have the bleed screw.Models equipped with the screw is loacted at the top of radiator
You should see a horizontal steel pipe just in front of the engine. This pipe has the bleeder screw.
need to know what engine.
its on top of the radiator to the left when your faceing it.you need a philipps screw driver
Its the bleeder screw, its used to let air pockets out the coolant system.
Yes, that is what the bleeder screw is for
To open the bleeder screw and release air, turn it counterclockwise (left). To close the bleeder screw after bleeding the system, turn it clockwise (right) until snug. Be gentle to avoid damaging the screw.
where is the coolant bleeder screw located on a 2002 ford escape
If the Cavalier bleeder can not be removed with pliers, try a screw removal tool. The tool has angled threads. Slide it into the broken bleeder then turn it, the threads will grab the bleeder and should back it out for replacement.
Bleeder screw for clutch is at the slave cylinder, on the bell housing of the Transmission. The bleeder for the brakes is on the calipers, and on the backing plate of the rear drum brakes
There is a bleeder valve. It is located on a metal coolant line. The screw for the bleeder is right next to the oil fill neck. It has a stick next to it that says do not vent when engine is running.
There is a bleeder valve on the passenger side of the intake manifold (Upper radiator hose connects to it). Open up bleeder screw and run engine so it gets warm enough to open thermostat. Run until air is bleed from system and then close the bleeder screw.
It should have a bleeder screw on top of the thermostat housing.