0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What are the intake manifold torque specs for Honda Passport 3.2l?
What are the torque specs for a 2001 Honda Passport head gasket
What is the intake manifold torque specs and ordering for the 3.4L on a 2001 Pontiac Grand Am?
need torque specs for 3.4 pontiac grand am intake and rocker arms
What are the intake manifold torque specs for a 2001 Ford F-150 4.2?
15lbs
What is the intake manifold torque specs for the 3.1L on a 2001 Pontiac grand prix?
The intake manifold torque specs for the 3.1 L on a 2001 Pontiac Grand Prix is 195 ft lb. and 264 Nm at 4,000 rpm. It also has 175 hp at 5,200 rpm.
What are the torque specs on upper and lower intake manifold for a 2001 Pontiac grand am 3.4 liter?
lower intake is 115 in pounds upper is 18 ft pounds
What are the torque specs for a intake manifold on a 2001 Nissan Altima 2.4 Liter 4 cylinder?
12 to 14 ft. lbs in sequence
What is the torque specs for 2001 Chevy silverado 6.0 l intake manifold?
step 1 is 44 inch-lbs step 2 is 89inch-lbs.
What are the torque specs for a Pontiac 3.8 intake manifold?
I'm pretty sure this is that same 3800 motor that gm uses in my mom's 2001 buick Le Sabre. Her intake was the fiberglass resin plastic and the torque specs are 89 INCH pounds. Make sure you use the right tightening sequence too. 89 inch pounds is for the upper intake or Plenum. 136 inch pounds is the torque specs for the lower intake
What is the torque specs for the upper intake on a 2001 dodge stratus 2.7?
105 in lbs
Where can you find the torque specs for the head bolt torque rocker arm torque intake bolt torque for a 2001 3.4 grand am?
It is in a shlp manual from AUTOBOOKSONLINE.COM
What are the torque specs for a 2001 Toyota Tundra intake manifold?
13 ft lbs but tighten gradually from the center out to each side. If you number them 1-5 tighten them as 3-2-4-1-5...
What is the intake torque specs and ordering for a 3.8L on a 2001 Pontiac grand prix?
The 2001 Pontiac Grand Prix 3.8 liter engine intake bolt torque specification is 45 pounds. The intake bolts should be torqued in 15 pound intervals.
