the pedal will slowly depress with no loss of fluid
A symptom you almost always feel is a brake pedal that will not hold. You stop, hold the brake, and the pedal will slowly move toward the floor. This is a sure sign the master cylinder is bad. A leaking master cylinder or one that sticks, is also a sign is is defective. When you replace the master cylinder replace all the brake fluid in the brake system and bleed the brakes. Moisture in the brake fluid will destroy a master cylinder and this may be why it failed.Brake fluid leaking from the master cylinder. When you stop and hold your foot on the break the brake pedal will slowly go to the floor. Either of these symptoms means your master cylinder must be replaced.
Soft clutch pedal that goes to the floor. Repeated pumping does not help.
how do i know the master cylinder is bad ?
A "Bad cylinder" or "dead cylinder" is a cylinder with Low compression psi. Symptoms: rough running low power can cause high oil consumption
The most common symptom of a master cylinder that has failed is that when you stop and hold your foot on the brake pedal it will slowly fall to the floor. This is called pedal fade and means the seals within the master cylinder are leaking. If you push the brake pedal and it does not return it may be defective. You may also see a leak at the master cylinder.
I believe your clutch master cylinder is bad. I replaced mine just last year because I couldn't put my car into gear. Every time that happened I had to open the hood and free the clutch lever because the clutch master cylinder went kaput.
The gasket to your clutch master cylinder is probably broken or cracked. or your master cylinder is bad.
Look for leaking fluid at the slave or master cylinder.
If the master cylinder reservoir is empty, you have a leak somewhere. If the master cylinder reservoir is full, the master cylinder is bad.
May be a bad master cylinder, a bad sending unit from the master cylinder or the parking brake or the parking brake is not completely disengaging.
After you have located the clutch slave cylinder, have someone depress the clutch pedal. You should see the piston of the slave cylinder extend somewhat. If it does not, either the slave cylinder is bad, or the master cylinder, or, there is not enough brake fluid in the system for it to operate properly. Check the level in the master cylinder. If the slave cylinder is leaking profusely, it is probably bad.