You didnt specify what year.i have a 94 b2300 and had to replace the grill and in order to replace i had to take the front bumper off just to get to dome of the screws.so be prepared.
You can't - well, you can.. but the front bumper cover and the grill are all one piece
Oh, dude, changing the front turn signal bulb on a 2006 Buick Lucerne is like a walk in the park... if that park was full of confusing car parts. You basically gotta access the back of the turn signal housing, twist out the old bulb, pop in the new one, and voila, you're signaling like a pro. Just make sure to not break anything or you'll be signaling with hand gestures for a while.
Front, grill, hood, bumper, etc
From inside the engine bay, under the hood, behind the front bumper, VERY carefully.
To replace the headlight assembly on on 03 Jetta, the grill and front bumper have to be removed before you can get to the screws below the lamp.
Usually to remove the front bumper grill you would just locate the screws or bolts holding the part in place and then remove them. The grill should be able to be removed after that.
To remove the front grill on a 2007 Chevrolet Tahoe the bumper will need to be removed first. After the bumper is removed, take off the four screws and clips holding the grill in place. The grill is then ready to remove.
Normally on the front bumper or in the front grill somewhere.
Behind the front bumper and grill and in front of the radiator.
Behind the front grill above the front bumper.
take all the clips out i believe its like 13 then clip out the grill and u set to go