Wiki User
∙ 12y agoYou can use a very small flat blade screwdriver if you know what you are doing.
Wiki User
∙ 12y agoRemove the fuel filter relay. Unbolt the fuel filter strap that holds it to the frame. Disconnect the lines to the filter and remove it. Reverse the process to install.
How do you change the fuel filter on a 1992 Chrysler New Yorker? Do you need a special tool to remove the quick disconnect? How do you change the fuel filter on a 1992 Chrysler New Yorker? Do you need a special tool to remove the quick disconnect?
To remove the cylinder head on an Astra 1.7 CDTI, disconnect the battery cable and remove the lower engine cover. Drain the cooling system and remove the oil filter. Remove the air filter hoses and disconnect the crank case breather hose from the valve cover.
. Disconnect and remove the battery and the battery box. Remove the upper IC pipe (If turbo'd) and throttle body elbow. Now you can see the fuel filter
# Remove rear seat cushion # Remove the fuel pump access cover # Disconnect the fuel pump electrical connector # Start engine and wait for it to stall # Disconnect negative battery cable # If necessary for access remove air cleaner assembly # Remove the clips and detach the hoses from fuel filter then remove the filter bracket nuts and lift the assembly out of the engine compartment
Disconnect the Mass Airflow Sensor connector. Remove 4 screws holding top of air filter box. Remove air filter. Reverse procedure to reassemble.
You disconnect the plumbing. Remove bolts on top. Start scooping.
Remove the fuel tank. Disconnect the fuel hose from the fuel pump to the junction of the carbs. Disconnect the fuel hose from the fuel filter to the fuel tank. Remove the fuel filter bracket. Keep track of the position of the fuel filter. Remove the fuel filter from the rubber holder. Disconnect the fuel pump electrical connector. Remove the fuel pump from its holder bracket A large screwdriver may be necessary to pry pump away from the holder bracket. . Remove fuel pump assembly. Remove remaining hoses from fuel pump. Installation is reverse of removal.
remove air filter and air filter box and then you can get to starter dont forget to disconnect battery
remove air filter and air filter box and then you can get to starter dont forget to disconnect battery
From the factory, the fuel filter would be in the Q-jet carb. You have to disconnect the fuel line at the carb and remove that housing on the carb. Filter is inside.
an ordinary crescent wrench will work just fine