No. You can reset the computer by disconnecting the NEGATIVE battery cable for a minute or so, but the light will probably just come back on. You need to get a Ford code reader from your parts store (usually about $30). This will come with a manual describing how to retrieve the codes and figure out what the computer is complaining about. Then you must fix whatever is broken to keep the computer from storing codes and lighting the light.
check engine
There is no reset button for the check engine light. It must be reset with an OBD scan tool.
The light is reset with a scan tool after the repair. There is not a button.
There is no reset button for the check engine light. You can have Mitz. do it for $$$ or you can remove the negative battery line for a few seconds and replace. That will reset the check engin light.
Press the odometer button while starting the vehicle. Keep holding down the button until the numbers disappear and the check engine light goes out. Release the button and all is well.
Sorry , there isn't a reset button - you have to have the Explorer scanned to find the trouble code(s) that caused the check engine light to come on . The problem has to be repaired before the check engine light can be turned off by using the OBD II scan tool
The check engine light on a BMW 525i is reset by pressing the trip reset button until the engine icon appears. The Check and DC buttons are used to navigate between menus and the trip button held to actual reset the selected error.
Is there a reset button on a 1996 rav4? Had it checked out, and said it need spark plugs and wires. Replaced it and check engine light still on.
If the problem was fixed, the check engine light should turn off after a certain amount of times of turning on and off the car.
That is the check engine light.That is the check engine light.
No, oil level does not cause the check engine light.
The service engine light is the same thing as a check engine light.