Yes, just make sure your amp can run at 2 ohms and you're fine.
No it will impose the voltage of the three series batteries across the terminals of the paralleled battery. Batteries can only be parallel when all of the voltage potentials are near equal.
A; both have are prone to consideration. In a series string any failure will make all of them to look like OFF In a parallel setup a failure can be easily ascertain however the power from each light will add up
A; both have are prone to consideration. In a series string any failure will make all of them to look like OFF In a parallel setup a failure can be easily ascertain however the power from each light will add up
Assuming all of the individual batteries are the same voltage, if arranged in a parallel circuit the voltage is the same as any one battery. If arranged in a series circuit the voltage will be the sum (the total) of all of the batteries added together.
Automobile headlights are typically wired in parallel. This means that each headlight is connected directly to the power source independently, allowing them to operate separately from each other. This setup ensures that one headlight can still work if the other one fails.
A flashlight typically uses a series circuit. In a series circuit, the electrical components are connected in a single path, meaning that the current flows through each component in the circuit. This setup allows for the proper functioning of the flashlight by providing power to the bulb from the batteries.
· Recall the ECP uses a DMA channel. Allow setup to keep DMA3 unless you suspect a conflict with another device trying to use DMA
arrangement, prearranged,
The problem you have there is that your sub woofer needs both coils wired and your options with that setup is either 2 ohms or 8 ohms depending on if you wire the sub itself in series or parallel. If you use a second sub like the first one and wire both subs in parallel and then wire the two subs in series you can achieve 4 ohms. You could also wire the subs in series ( 8 ohms each ) and then wire them in parallel to achieve the overall 4 ohms.
Parallel and series connections differ in their connection to the feed line. In parallel, each pump is fed directly from the feed line. This means that the water going into each of the pumps is at exactly the same state and the pumps may be analyzed individually. In series, the water is fed through one pump, then the exit line from that pump leads to inlet of the next and so on. What determines the setup for a specific application is the desired property of water at the exit. Two pumps in parallel connection can produce a higher flow rate. Two pumps in serial connection can produce a higher pressure.
One's PC setup is a personal thing. What is good for one person may not be a good setup for another. For example if you want to play games, you will want to ensure that you have a good gaming setup, while someone who likes music would need a different setup.
You press a series of buttons in the controller setup screen