answersLogoWhite

0


Best Answer

Check the specs for the vehicle you are working on (You can find them on the net if you do not have the manual) and the torque requirements will be there.

Do not over torque the bolts as removing a broken valve cover bolt is a pain.

Good luck.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How tight should bolts be so oil wont leak from valve cover?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you tighten a valve cover?

There are valve cover bolts around the perimeter of the valve cover. You want these tight but not as tight as you can get them.


How tight does the bolts on a 94 Dodge Intrepid valve cover have to be?

The bolts on a 94 Dodge Intrepid valve cover need to be very tight. You should tighten to 12 N*m or 105 inch pounds.


How tight should the head bolts be on a 1994 Geo Tracker Also how tight should the valve cover bolts be?

46-50 ft.lbs. 46-50 ft.lbs.


What is the torque for valve cover bolts on 454 ci Chevy engine?

15 to 20 inch pounds should do it, or what feels tight with your fingers.


With what force should you tighten your valve gasket cover for a nineteen eighty eight Honda prelude SI?

most valve gaskets should be tightened with i believe about 1- 3 lbs of torque,however most torque wrenches don't go that low so barring a wrench just good and hand tight will suffice,be warned that too tight will shear off your valve cover bolts and trust me that's a pain


What is torque spec for 2001 altima valve cover?

The 2001 Nissan valve cover bolt torque specification is 45 pounds. The valve cover bolts should be torqued in 15 pound intervals.


How do you change the valve cover gaskets on a 1981 Ford?

Just did mine on my 300 cu in Ford 1982. Remove any parts that might be in the way, breather, gas line over the valve cover etc. Remove the bolts around the outside of the valve cover. Remove valve cover. Remove old gasket. Clean valve cover. Install new gasket and re-install cover. Replace bolts. Finger tight bolts first then tighten. If you do not have a torque wrench, carefully tighten down bolts alternating from one side to the other tightening them all down evenly. Do not overtighten, they will snap off into the head.


How do you change a valve cover gasket for a 1995 altima?

Take off the valve cover. there is about 8 to 12 bolts. just take it off and take off the old gasket, then clean off old gasket residue with a razor knife, then install the new one and put the cover back on. the bolts dont need to be extremely tight.


What is the valve cover torque on a 2000 Mazda Protege 1.8L?

The 2000 Mazda 1.8 liter engine valve cover torque specification is 45 pounds. The valve cover bolts should be torqued in 15 pound intervals.


Where are the head bolts located prelude?

Your head bolts are located under your valve cover. Take your valve cover off and you will see them. Hope this info. helped.


How do you keep tight valve cover bolts On a 1983 Chevy 350?

They don't usually need any special effort, but a little loctite 242 would help.


What are the size of bolts for miata valve cover?

4x4