The Mitsubishi 4G54 engine uses a flywheel with a ring gear that has 131 teeth. This ring gear is essential for the starter motor to engage and crank the engine during starting.
Depends. There were 168 and 153 teeth. Both were used on 305's.
The small ones have 153 teeth, the large ones are 168.
You can't just replace the teeth, you have to replace the whole flywheel
The flywheel can be cracked or the teeth on the flywheel can be broken or worn. Either of these conditions require the flywheel be replaced. I would also replace the starter when replacing the flywheel. This will prevent damage to the new flywheel from the worn teeth on the old starter.
A bad flywheel can definitely cause the engine not to turn over. The flywheel has teeth. If the teeth are chipped or broken, then the starter can not engage to spin the engine over.
The flywheel for the FWD tranny should have 6 bolts. The turbo flywheel has 100 teeth and the nonturbo should have 106. The AWD flywheel should have 7 bolts.
if the starter is spinning but not engaging then the bendix (starter teeth) is not moving out to grab the flywheel teeth or the flywheel has some broken teeth. The starter needs to be removed to see what the issue is.
Assumeing it's the same starter, the bendix(the gear on the end of the starter that engages the flywheel)could be bad, and or the starter it self could be bad. sounds like number of teeth on new flywheel does not match number of teeth on starter. find out from mechanic that installed new fly wheel, how many teeth on flywheel if he doesnt know, a ford dealer can tell you from the part number on your receit. then ask how many teeth should be on starter to match fly wheel pull starter and count teeth
No No. Flies vomit on their food to dissolve it then suck it up with a straw like extension. A flywheel has teeth.
the starter bendix is bad or the flywheel it self has some teeth missing The Starter Bendix drive is not close enough to the flywheel. Reinstall the starter and check to see if there are shims that can be removed to place it closer.
By crank wheel I assume you mean flywheel. The answer is you take the transmission off and count them.