answersLogoWhite

0


Best Answer

How many bolts are on the 454 1984 chevy

User Avatar

Wiki User

βˆ™ 12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How many bolts are in a cylinder head?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How much is the torque of 2c cylinder head bolts Toyota?

torque for 2c engine cylinder head bolts


Torque setting for cylinder head bolts for a Skoda felicia?

torque setting for cylinder head bolts for a skoda felicia


What is Toyota Camry cylinder head bolts torque specs?

The torque specs for a Toyota Camry cylinder head is 60 pounds for the inside bolts and 50 pounds for the site bolts. The cylinder head bolts should be tight from and to end alternating.


What is Chevrolet small block cylinder head torque spec?

65 on the long bolts 45 on the short bolts


How do you install cylinder head bolts on a 1996 Saturn?

What are the torque specifications and the tightening sequence of the cylinder head bolts on a 1996 Saturn SL1?


How many bolts on a 1998 Chevy Tahoe cylinder head?

There are 17 bolts 8 lower 5 middle 4 upper


Do you need to replace cylinder head bolts on a Nissan Sentra when changing cylinder head gasket?

Yes


What is the cylinder head torque specs for a 1995 Ford Escort 1.9 liter Thanks?

Use new bolts. Apply a light coating of engine oil to the threads of the new cylinder head bolts. Install the new cylinder head bolts to the cylinder head. Tighten the cylinder head bolts to 40-60 Nm (30-44 lb-ft). The sequence is to start at the middle bolt on the intake side of the head, then move to the exaust side, then move out to the ends of the head in a criss-cross pattern. Loosen all cylinder head bolts approximately two turns, then retighten the cylinder head bolts to 60 Nm (44 lb-ft). After tightening, turn all bolts 90 degrees, in the same sequence. Complete bolt tightening by turning them an additional 90 degrees, in the same sequence.


What is the cylinder head torque on a Toyota Paseo?

The cylinder head on a Toyota Paseo requires 33 pounds of torque on the head bolts. If the bolts are over tighten the block can warp leading to a blown head gasket.


What are the cyl. head bolt torque specs for a KIA 1.8 L 2000?

Hello: Install cylinder head bolts. Tighten cylinder head bolts according to following procedure: Tighten cylinder head bolts in order shown, Can not show diagram for this. Tightening torque : 36.1 lb-ft (49N


Torque specs on a head bolts for a 1991 yz 125?

The cylinder head bolt torque specification is 90 pounds. The cylinder head bolts should be torqued in 30 pound intervals.


What are the torque settingsand tightening sequence for the cylinder head bolts on a Kia Sedona 2.9?

http://wiki.answers.com/Q/What_are_the_torque_settingsand_tightening_sequence_for_the_cylinder_head_bolts_on_a_kia_sedona_2.9 the cylinder head bolts on a kia sedona 2.9?"