0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How does a camshaft position sensor work and how can you get it to set a code without unplugging it?
the cranshaft and camshaft position sensor. the engine speed and cranshaft position information is supplied frome a sensor which is usually situated at the front or rear of the cranshaft.note that distributor-located engine speed sensor are generally being replaced with cranshaft-located sensors,as worn disributor drives and associated components can effect the accuracy of the engine speed signal. A camshaft position sensor,or cylinder identification sensor is used to determin the engine cycle position the information is used to provide individual cylinder ignition and injection cotrol.Many engine management systems use an inductive type of sensor that is located near the camshaft;when the camshaft rotates a single signal is passed to the ECU to indicate a reference point in the engine cycle.Some system manufactures may use a Hall effect-type sensor.
Can you drive your 2005 Chrysler Crossfire if the camshaft is bad?
NO. If the camshaft is broken it will not run. If the camshaft is worn it will run poorly.
What is effect of excessive wear of rocker arms valve contact point to engine operation?
rocker arms operate the valves that allow fuel into the cylinder and exhaust out. if they are worn then the valves won't fully reducing fuel admitted and so reducing power output for the effect.
How do you replace a 1999 Saturn sl camshaft Do you need to remove the head to do so?
NEED to??? No. But the question becomes, why are you replacing the camshaft? You should always replace the lifters when replacing the camshaft. A worn camshaft usually indicates that there will be other wear as well, but if you just want to squeeze a few more miles out of the engine, you might be able to get by with just replacing the cam and lifters.
What are the effects on valve timing if the peaks of all cam lobes become worn?
If the peaks of the cam lobes are all worn the camshaft needs to be replaced. It will affect the valve timing and the air intake into the engine which in turn affects the performance.
Will car run with worn camshaft bearings?
go bak to scholl
Valve adjustement 4.3 blazer s10?
There is no valve adjustment on that engine. If you have noise coming from the valve train you probably have worn parts such as camshaft, lifters, pushrods, rocker arms and valves.
What can a worn camshaft or crankshaft bearing cause in a motorcycle?
Friction, wear, and finally a breakdown.
What is the usual cause of the number one cylinder lifters to be tapping in a Chevy small block 305?
Could be, Out of adjustment Worn camshaft Worn lifters Worn pushrods Worn rockers All of the above.
How do you you reduce engine blow by on a high performance engine?
Replace the engine or have it rebuilt. Once an engine is worn to the point that it has excessive blow by, those are the only real solutions. You could try using a heavier engine oil, but the effect that will have is negligible.
Why after replacing raditator for overheating water pump and new spark plugs would the 04 jeep Grand Cherokee still be missing in the engine and carrying on jumpy like?
possible cracked head and a worn camshaft lobe
Can the timing gear that you see when you remove the distributor on a 1969 350 Chevy engine be pulled out while removing the distributor and change the position of the gear that drives the distributor?
There is a gear on the distributor shaft and a gear on the end of the camshaft that it engages with. The gear on the camshaft cannot be removed as it is part of the camshaft. The gear on the distributor shaft can be removed if it is worn; however, this is rare. These two gears must be in proper mesh for the engine to run; one cog off and it will not start.If you need further assistance google ' finding top dead center on a 350 chevy'.
