0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you make the Remington wingmaster 870 hold more shells?
Take the plug out of the mag. unscrew the cap, pop out the spring stopper with a screwdriver. remove the spring and plug. Put the spring back in without the plug.
2007 big bear 400 oil drain location?
17mm plug in the bottom of the engine case. there will be a spring and screen that comes out with it
How do you reset sony big screen tv?
Unplug it from the wall for about a hour then plug it back in.
Can a Wii overheat?
Yeah. The fan broke on mine and the screen freezes every now and then. just unplug it from the back and let it sit for about a minute. Also, if your screen freezes, just unplug it from the back and then plug it back in.
What to do when iPod only shows white screen?
Plug it into your computer and restore it. Or if it's not jailbroken take it back.
How do you change the oil filter on a Honda xr200?
On the left side in front of the shifter is the drain plug. My 2002 xr 200 does NOT have a oil filter but an oil screen. Take that out also and clean. Put back in with spring and nut, fill with oil an go play.
How do you get the plug out of a browning 2000 shotgun?
Remove the gas system. Drift out the black cross pin out of the magazine tube. The pin is directly below the gas system through a polymer plug. The polymer plug should come out of the top of the magazine tube when you remove that pin, so be VERY careful when removing the pin. Now remove the magazine spring. On the follower end of the spring should be the plug you are wanting to remove. Remove it from the spring. And put the spring and polymer plug back in. The dished end of the polymer plug goes toward the end of the magazine tube.
What do you do if ihome front screen not showing up but the iPod is charging?
unplug it wait a few days and then plug back in
How do you assemble a Colt 1991A1 Compact?
With the exception of the recoil spring plug, all else is the same as the 1991 A1 5". The plug comes out with a turn and goes back in with a turn, which unlocks/locks the lug on the plug.
How do you remove the plug from 20 ga Winchester 1200?
The "plug" in your 1200 is just a stick slid down inside of the magazine spring to limit the number of rounds that will fit in the tube. Keep in mind that there is a big long spring inside that magazine tube and if you're not careful, when you unscrew the cap at the muzzle end of the magazine tube, it's going to go flying across the room. Once the cap is off, remove the wooden (or plastic) "stick" that will be tucked inside the spring. Push the spring back in and put the cap back on. Save the plug, you may want to put it back some day.
How do you remove the plug from a Remington 870 express?
To remove the plug on a Remington 870 series all you need to do is unscrew the cap on the end of the magazine tube. Carefully because it holds in the magazine spring. the plug is the rod that is inserted in the spring so it cannot compress fully to limit capacity so just take it out and screw the cap back on (the cap compresses the spring) and voila. takes about twenty seconds.
How do you change the resolution on my PS3?
Go to the settings on the MXB and go to display settings then follow the on-screen guide by choseing your type of plug. Followed by chose your resolution ex.(1080i, 1080p, 450, 720). Your screen will go black and if you have chosen your resolution that your tv can support it will go back to the screen you were before. then you are given a choice of screen size and voila you have sucessfully chosen your resolution as well as plug type and screen size.
