You will need an OBD2 scan tool or code checker to read the code. There is no shortcut on resetting the lamp. It's coming on for a reason. Find out which code is setting, repair the condition and then clear the code. Most of the time, once the repair is made, the vehicle will need to make two or three "trips" without a failure before the lamp will reset. Russtech67
The check engine light on a Buick Regal can be reset with a special diagnostic scanner. This can be performed at a car dealership or service garage.
Yes
I have a Buick Regal LS and I had them run a computer diagnosis and it was due to the gas cap not fitting properly. There is an electronic sensor there. Most automotive stores will do this check for you free of charge.
how do you reset check engine light in 2008 buick lucerne
If the check engine light does not flash when in the diag mode, the problem is the computer. Could be as simple as a failed lamp driver but a failed computer is toast and will need to be replaced/
Why is my security light on and will not let my key come out of the ignition. 1999 buick regal
engine light
You can only reset it with an OBDII diagnostic scaner
how do you change the rear license plate light on a 1999 Buick Regal
Disconnect the negative battery cable for 10 seconds.
The check engine light on the 1998 Buick Park Avenue can be reset by disconnecting the battery for a few minutes and then reconnecting it. The check engine light is only going to stay off if the problem that created the light is fixed.
CHECK BOTH THE INTERIOR FUSE AND THE COURTSY FUSE