'Engine Airbag Code Reset Tool Vauxhall Meriva Zafira
Car due a service? It will need to be reset by a main dealer
Reset the exhaust emission warning light by turning the ignition on and off 40 times. Light codes can be read by the old brake/accelerator press and turn the ignition on.
The best way to reset the engine warning light on a Nissan Primera p12 would be to take it to a mechanic. It is best to have a mechanic check it out to make sure nothing is wrong that could malfunction and put someone in danger. The mechanic will be able to reset the engine warning light.
whats mean dtc P1700 on zafira Z18XE.thanks
whats mean dtc P1700 on zafira Z18XE.thanks
Try to reset any engine warning lights after the situtation if resolved by disconnecting the positive post of the battery for at least 30 minutes. This gets the computer time to possibily reset and eliminate the warning light.
What warning light? The only warning lights that can be reset are the Maintenance Required and Check Engine Light. The Maintenance Required light is reset in different ways depending on model and year. The procedure is listed in your owner's manual. Reset the light after performing scheduled maintenance listed in your owner's manual, usually oil/filter change. The Check Engine light is reset by repairing the problem then unhooking the battery for 15 minutes, on a pre-1996 vehicle. On a 1996 and later vehicle it normally requires you use an OBD2 scan tool to reset the light. If you do not repair the problem that set the fault code, the light will just come back on. Your oil pressure warning light means you have low oil pressure, temp warning light means the engine is over heating, alternator light means the charging system has a problem.
It is important to pay attention to the warning lights on a car. To reset a service engine light on a car, a person must fix the problem causing the light to go off.
When there is a component on the engine that is malfunctioning the warning light will turn on. The code should be assessed for what needs to be replaced so the light can the be reset.
You cannot reset yourself. It should have been done by the garage after they had serviced it. Actually, you can reset some, but you'll most likely need an OBDII computer to do it. The port is under the hand brake (emergency brake) handle on my 1999 Zafira. Also, the garage may have reset your service engine light and it came on again for something else. Make sure you get a complete list of codes from the OBDII tester. Often the culprit is a loose gas cap. Take it off and reseat it then let reset the light after 2-3 engine starts.
how to reset a srs warning light on 307 203 model