1) Open the hood. If you need to change the headlight bulb on the driver's side, remove the Power Steering reservoir tank by pulling it out of its holder 2) Remove the elctrical connector from the bulb by squeezing the connector on both ssides to unlock the tab. Pull the connector straigh off 3) Remove the rubber weather seal by pulling on the tab 4)Unclip the end of the hold-down wire from its slot. Pivot it out of the way and remove the bulb 5) Insert the new bulb into the hole, making sure the tabs are in their slots. Pivot the hold-down wire back in place and clip the end into the slot 6) Install the rubber seal over the back of the headlight assembly. Make sure it is right side up; it is marked TOP 7)Push the electrical onnector onto the tabs of the new bulb. Make sure it locks in place. Turn on the headlights to test the new bulb 8) Reinstall the power steering reservoir
Order replace done
To replace a headlight on a 2002 Honda Civic first prop the hood open. Locate the headlight housing inside the engine compartment. Find the bulbs and remove them. Install the new bulbs.
drop the bumper and take the headlight housing out
The headlight dimmer switch is located on the end of the lever. Remove the steering column so the lever can be properly reached.
The headlight on a 1985 Honda Civic is changed by lifted the hood open. Locate the housings for each headlight and find the harnesses for the bulbs. Pull out the old bulbs and replace them.
its located under the left front headlight.
It should be the same way as the 90 and 91 just a clip holds the light in
Grounds for a headlight on a 2002 Honda Civic are found stemming from the wiring of the lights themselves. To replace a ground remove the old wire and solder on a new one.
Head over to YouTube and there are many informative videos on how to do this.
part and labor?
how to replace the thermal switch relay on a 1992 Honda civic lx
The headlights on a 1998 Honda Civic use adjustment screws which are located on the side of each headlight in the engine bay. Tightening it will raise the light and loosening it will lower it.