0
To replace the rear taillamp bulb in an 2002 Isuzu Axioum:
1. Open the rear tailgate.
2. Remove the two screws that hold the tail lense asembly in place.
3. Now there are two pins that hold the lamp in place you must use a screwdriver or other flat device and lightly pry the lense out to the right or left of the vehicle depending on which side your are working on. If you pull back it will not come out as you are putting pressure against the pins it must be pulled toward the side that the vehicle you are trying to remove the lense on.
example: changing the right lamp. {} denotes the lense and the diagram we are looking from the back of the vehicle
{}_____{} -->Pry this direction.
Good Luck I called three dealers and none knew how to do it. I finally figured it out with a flash light and looking in to see what was holding it.
You're making this way too complicated. All you have to do is take the screws out, hold onto the housing with one hand, stoop down a little and give the flat side of the housing - 90 degrees to where the screws were, a little bit of a bop straight toward the outside of the car with the bottom of your palm or side of your fist and the plastic clamps, in the light housing, pop off the posts(called pins above). It needs to be a firm little pop, not a Chuck Norris karate chop. The posts have a little lip on the end that the plastic clamps have to be forced over. If you pry on the light housing your going to scratch or break something. A little chop to the inside of the light housing pops the plastic clamps off the posts and the housing is free. After you get it off and look at it, it will all become clear to you. To put it back simply place the plastic clamps over the end of the posts while holding the housing in place, and, more gently than the removal, pop the clamps back over the posts with the side of your hand and put the screws back in.
What else can I help you with?
How do I replace brake light on 2004 Isuzu Axiom?
To replace the brake light on a 2004 Isuzu Axiom, first, open the rear hatch and locate the tail light assembly. Remove the screws or clips holding the tail light in place and carefully pull it out. Disconnect the wiring harness, then twist the bulb socket counterclockwise to remove the old bulb. Replace it with a new bulb, reassemble the tail light, and ensure it’s securely fastened before testing the brake lights.
How do you take dash apart in 2002 Isuzu axiom to change light bulb?
take out light bulb in a dash
How do you replace the he ad light bulb on a 2002 Isuzu axiom?
It is really simple. You simply open your hood reach in behind the headlight lamp, and twist the bulb out and unplug from the wire. Replace with new bulb and reverse the steps.
Why do the antibrake and brake light stay on my 1990 Isuzu pickup tuck?
there is asensor on the rear diff...replace that and you should be ok
How do you replace the brake light for a 2000 rodeo Isuzu?
To replace the brake light on a 2000 Isuzu Rodeo, first, open the rear hatch and locate the tail light assembly. Remove the screws or clips holding the assembly in place and gently pull it out. Twist the bulb socket counterclockwise to remove it, then replace the old bulb with a new one, ensuring it's securely fitted. Finally, reassemble the tail light by reversing the steps and test the new brake light to ensure it works.
How do you put an Isuzu axiom into 4 wheel drive?
Switch to TOD and drive about 5mph. Once all 4 tires light, switch to 4H while rolling slowly and in neutral. Might have to step on brake?
How replace brake light switch in Isuzu Ascender?
To replace the brake light switch in an Isuzu Ascender, first, disconnect the negative battery cable to ensure safety. Locate the brake light switch, which is typically mounted above the brake pedal; you may need to remove a cover to access it. Disconnect the wiring harness from the old switch, unscrew it from its mounting position, and then install the new switch by reversing the process. Finally, reconnect the battery and test the brake lights to ensure they function correctly.
Isuzu NPR green dash light?
Its the engine brake light
What fog light bulbs do you use for 2002 Isuzu Axiom?
AC DELCO FOG LIGHT BULBPart Number: AC9006BManufacturer Number: 9006BHope that helps.
How do you replace brake light on a 1995 Isuzu Rodeo?
If its the bulb you have to unscrew the light cover and pull out the old bulb and put the new one in.Then screw the cover back on.
How do you change the tail light on a 2002 Isuzi Axiom?
To change the tail light on a 2002 Isuzu Axiom, first, open the rear hatch and locate the tail light assembly. Remove the screws or clips securing the assembly and gently pull it away from the vehicle. Disconnect the wiring harness and replace the burnt-out bulb by twisting it counterclockwise. Reassemble the tail light by reconnecting the wiring, securing the assembly, and testing the new bulb.
Where is the battery light for a 2002 Isuzu axiom?
In a 2002 Isuzu Axiom, the battery warning light is located on the instrument panel, typically among the other warning lights. It usually resembles a battery symbol or the word "BAT." If this light illuminates while driving, it indicates a potential issue with the charging system, such as a failing alternator or a weak battery. It's advisable to check the vehicle's electrical system promptly if the light comes on.
