After successfully removing the engine cover, remove the 10mm bolt that holds down the ignition coil remove it (continue this for all 6 cylinders as this engine is COP or Coil on Plug) , then using a blow gun or air gun blow any debris from inside the spark plug tube, using a 5/8" spark plug socket and a 4=6" extension remove the spark plugs. Be sure to check the gap on your new plugs (.044) then re-install the plugs, ignition coils, 10mm hold down bolts, and then the engine cover. Good Luck!
This is "BBAASPENCER" here in TN and I would like to give you another answer. Actually, the correct way GM list in their service manual is to take off the engine dog bones, attach a pulling strap to the engine and hoist and roll it until you gain access. That is the same procedure for many SUV/Van GM front wheel drives. If the first procedure listed here works for you, I'm okay with that. I just wanted to give you another option. Here is a video on this new engine tool. Will try it soon to see of it works. http://www.YouTube.com/watch?v=tlIkbbl7cBo
change sparkplugs on 2003 Rendezvous
how to replace starter for a 2002 buick rendezvous
how do you replace a 2004 buick rendezvous input speed sensor
how to remove starter on 2004 Buick Rendezvous
replace 2002 Buick rendevous motor mount
How much can cost repair to change head gasket Buick Rendezvous 2002
replace 2002 buick rendevous motor mount
where is the switch resistor on 2003 buick
Take your door panel off and replace them...
remove gas tank and replace fuel pump
Buick Rendezvous was created in 2001.
In order to replace the drivers side mirror on a Buick Rendezvous, you will need to remove the door panel. You will have to disconnect the electrical connector and you will be able to remove the mirror and place the new one on.