Remove serpentine belt. Remove pulley. Install new pulley. Install serpentine belt.
yes,a good parts man will give you a belt to bypass your ac.
no adjusting bolt u have a serpentine belt.that has a tension pulley that automatically adjusts if belt is loose, u need to replace belt
I need the routing for the serpentine belt for 1990 Ford 150?
Serpentine puller
the belt tensioner does it by itself.short answer no
The tension on a 1988 Ford F150 can be loosened by adjusting the belt tensioner. The retaining bolt is loosened, the tensioner shifted slightly, and tightened down.
its under your hood with the firing order and distributor order
I need a diagram for a serpentine belt for a 1994 f150 with 5.0 engine I need a diagram for a serpentine belt for a 1994 f150 with 5.0 engine There should be a sticker near radiator shroud that has belt routing. If not stick the belt down past the right side of fan/water pump .put belt on crank pulley then pull back of belt over water pump and then down around power steering pulley and up over compressor pulley. put belt from crank pulley around smog pulley then up to tensioner with back of belt around tensioner and then around alternator pulley.next put rachet and socket(15 mm) on tensioner and pull on it while placing belt under idler pulley.
The serpentine belt has a tensioner that you nust pry up to remove the belt. There should be a schematic of the routing of the belt on the fan shroud. If not, draw one before removing it.
The squeal you speak of is belt related, yes; but it is not the belt. There is a belt tensioner ( the part you had to pull up to remove and replace the belt). Inside this tensioner, the bearing goes bad causing the squealing sound you describe. Replace the tensioner (pulley or assembly) and the noise will go away.
How do I disable seat belt alarm for a Ford F150 2004