0
Safely raise and support the rear of the vehicle. Remove the center nut (22mm or 24mm - not sure). Remove the Phillips drum retaining screws. Remove the drum.
Remove the hand brake mechanism springs noting their position very carefully. Wrong installation of these can cause not only no parking-brake application but also weak braking application. Remove the remaining springs. Do not disconnect any lines or disassemble the cylinder or subsequent bleeding will be required.
The brake shoes are usually the same size. However, should one be a little longer it should go to the back side of the backing plate.
Reverse procedure to install and do be careful with positioning springs in same areas. Use other side as reference.
Add your answer:
Earn +20 pts
How do you change the brake light on a 1996 Mazda MX6?
open boot/trunk undo 2 screws on top of rear lens and slide out replace bulbs and refit
How do you put brakes on a Mazda mx6?
take off the tire remove the caliper replace the brake disc if necessary and replace brake pads on the calipers reassemble do this for every tire to wish to change at that time
How do you replace the ignition distributor on a 93 mx6 v6?
How do you replace the ignition distributor on a 93 mx6 v6 pics?
Is the Mazda MX6 a rear wheel drive?
all front wheel driven
How do you replace fuel injectors 1990 Mazda mx6?
Take out the old ones and replace them with new ones.
How do you remove the rear brake drum from a Mazda MX6?
You need a big Socket (32MM I believe). Once you take off the nut the Drum will come right off. I have '95 MX6. Yes, a 32MM socket is needed. However, it is also possible that a large jaw clamp puller may need to be used in order to dislodge the bearings from the spindle. They seem to get stuck on there.
What is the cost to replace a CV Joint in a 1994 Mazda MX6?
afew bucks pretty cheap price it out and it will surprise you...
Why would a Mazda MX6 tail light warning light come on when the brake pedal is depressed?
Check bulbs to make sure all are working
Brake light is dim on driver side when brakes are engaged but pass. side is bright on 92 Mazda mx6?
there is a bad earth on your car somewhere
Witch parts do you replace in manual transmission when it brakes in a 93 4 cil Mazda mx6?
How long is a piece of string ????
Where are the two screws so you can replace the brake light on the 1993 mx6?
It is more than just 2 screws. The screws are.... right side of taillight on drivers side. and left side fo taillight on passenger side. There are also black clips on the inside of the trunk under the carpet.
How do you replace the ball joints in a 1990 Ford Probe?
This is not an easy job to do yourself if you only have little knowlege. Get the Haynes Manual MAZDA 626 & MX6 FORD PROBE 1993_2001. No. 61042 This will tell you in detail how to remove & replace the balljoints . This is not an easy job to do yourself if you only have little knowlege. Get the Haynes Manual MAZDA 626 & MX6 FORD PROBE 1993_2001. No. 61042 This will tell you in detail how to remove & replace the balljoints . This is not an easy job to do yourself if you only have little knowlege. Get the Haynes Manual MAZDA 626 & MX6 FORD PROBE 1993_2001. No. 61042 This will tell you in detail how to remove & replace the balljoints .
