The 1999 Dodge Durango overhead console wiring connections are beneath the overhead console. You will need to remove the overhead console?æin order to access the wiring connections.
In ebay.com, search by overhead console.
To remove the overhead console you will first need to disconnect and isolate the negative battery cable. Remove the overhead screws and pull straight down on the console.
yes
distance till empty
unhook neg battery cable, this worked for me on my 2005 when this happened
See http://en.allexperts.com/q/Dodge-Repair-809/replacing-dome-light-switch.htm
Time for an oil change.
Check engine light and an improper reading in the overhead console.Check engine light and an improper reading in the overhead console.
I figured it out. Upclip the two clips closest to the windshield and move console back toward the read of the cap. There are two L shaped hooks at the read the hook into the top of the cab.
The holder replacement will depend on the model of the Dodge vehicle. Most of the holders have small pins on the sides that they hinge on. Bending the sides in gently should release the pins from the pin holes, allowing removal and replacement.
# Disconnect and isolate the remote negative battery cable. # Remove the overhead console retaining screw, located in the front of console near the windshield. # Using your fingertips, grasp the sides of the overhead console and pull straight down evenly to disengage the two snap clips at the rear of the unit. # Lower the overhead console far enough to access the wire harness connectors. # Disconnect the control module, courtesy lamps and if equipped, the power sunroof switch electrical connectors. # Remove the overhead console assembly from the vehicle.