Accelerator pedal sensor error
Nissan almera pedal sticking
Accelerator cable? No. Accelerator pedal set up? Yes.Looks like 2 bolts to remove the pedal clusterfrom the floorpan and then there is a bolt going through the pivot for the gas pedal.
It is on the accelerator pedal. You have to replace the whole pedal assembly
It is the accelerator pedal.
The 2005 Nissan Quest OBD 2 port is under driver side dash above accelerator pedal
replace the fuel filter and the accelerator cable to the throtle body
You replace it, I have never heard of repairing them
It's apart of the accelerator pedal. If you suspect it's bad replace the pedal assembly as a whole.
The accelerator pedal is to the right of the brake.
It is located behind the center console near the accelerator pedal and is held by 2 screws.
This project is fairly simple. there are a few bolts and a electrical connector that hold the accelerator pedal in place. the accelerator and sensor are all inclusive. look under the drivers side at the pedal find the bolts and electrical connect remove and replace. it's very simple no real technical expertise required.