0
Add your answer:
Earn +20 pts
How do you change spark plugs on 1991 infiniti Q45?
how do you change the spark plugs on a 1991 q 45 infiniti
Where do you find the spark plugs on a 91 caprice?
There are four spark plugs on each side of your 1991 Chevrolet engine. The spark plugs will be near the bottom of the engine.
Where are the spark plugs located in Toyota Previa models from 1991-1996?
To change the Spark Plugs on a Previa (1991-1996) you have to remove the passenger front seat, lift the carpet and then you will find a cover on the floorplate that has to be removed. Once the floorplate cover is off you will see the engine. There is also a small cover over the spark plugs and wires that has to be removed. The 2.4 liter petrol engine uses small 16mm spark plugs and a small 16mm socket will be needed to replace the plugs.
How do you get to the rear spark plugs on a 1991 Chrysler LeBaron v6?
If you remove the air filter box, you will have plenty of room to access the plugs.If you remove the air filter box, you will have plenty of room to access the plugs.
Where are the spark plugs on a 1991 Mercedes-Benz located?
In the engine... If it is a a straight six. They run in a row. follow the spark plugs wires to them.
How do you set the timing on a 1991 jetta diesel?
You only set the timiming for engines with spark plugs, and diesels don't use spark plugs.
What is the spark plug gap for a 1991 mercury marquis?
The 1991 Mercury Marquis spark plug gap is .034. Most spark plugs will be pre-gapped by the spark plug manufacturer.
What is the correct gap for spark-plugs on a 1991 Dodge Sprit?
0.35
What is the gap on the spark plugs for a 1991 Pontiac 6000 le?
.060"
What do you gap the spark plugs to for a 1991 Toyota 4-runner?
.031 in
How do you change spark plugs on a 1991 Pontiac Grand Am?
The first 3 spark plugs to the right are easy to change,the one on the left you have to loosen up the alternater to get to.
How do you change the spark plugs in a 1991 acura integra?
disconnect the negative battery cable remove the spark plug boots and make sure you know witch one goes where remove the plug use a 5/16 spark plug socket gap the new plugs to 0.041 in apply antisieze to the threads of the new plug apply a little silicone dielectric compound to the end of the spark plug lead install the spark plugs and tighten to 16 ft lbs put the boots back in annnnnnd your done.
