Remove - battery cable Remove + battery cable Remove hold-down bolt on front bottom of battery tray Remove battery
Remove the cables from the 2001 Monte Carlo, then take out the battery hold down. Lift the battery out and put the new one in. Install the hold down, then connect the cables back.
first remove the cables from battery, neg, than positive, remove hold down bolt on bottom of battery. remove battery.
you remove the battery hold down brace and voala! its done!
Remove air filter top cover, remove battery cables(neg. first) remove battery hold down.
First, take the battery cables off then remove the battery hold down then remove the battery. Reverse order to install. Be sure to clean the cables.
Remove the bolts that hold down the battery, remove the negative, remove the positive, and then pull it out. To install, do the following steps in reverse order.
renove 2 large Phillips screws on both rear side covers. then remove two 12mm bolts that hold down the seat and then remove hold down across battery with two 10mm bolts and then remove negative wire first from battery then the positive wire and lift out the battery. Congratulations you did it.
Take the cables off of the battery. Remove the battery hold down clamp and lift the battery out. Set the new battery in, reinstall the holddown, then connect the cables back.
You need to remove the panel from in front of the passenger side front tire to access the battery. You will also have to remove the air filter housing to get at the battery hold down so you can remove the battery. Hope this helped.
all you need is an 8 millimeter wrench for the battery cables and a 13 millimeter socket, extension and a ratchet to remove the battery hold down. the battery hold down is at the bottom ofthe battery, and is shaped like a wedge .has a bolt through the middle of it.
The correct size socket and ratchet to remove the hold down. And the correct size socket to remove the battery cable clamp.