I am thinking you are talking about the rear corner lights pull back the carpet to see the light socket twist remove from the housing remove the metal clip keep clip put new light in replace clip put back in housing and twist replace carpet and shut trunk you are done
No, it can be quite fiddly.
you open the bonnet and then you go to the back of the headlight and youll see a wire and clip attached to the black casing unclip that wire and then unscrew the black plastic screw then youl have a clip unclip it and then pull out your light bulb and then put a new one in and put the clip back on and
You unscrew the original back of the pokewalker OFF of the pokewalker, then replace it with the back with the clip.
remove rubber glove off back of light fitting pop out clip change bulb and put back together you will need needle pliers to pop out clip.
Go behind the headlight under the hood and turn the light bulb out,there is a clip holding it in place, snapped out of it,put the new one in get the clip back on it and turn it back in the headlight house
there is a white clip inside the hood. pull it up alittle...then pull the entire light cover off...then just replace the light and put it back in. be sure not to force in back in or you will break the white plastic clip! (like i did) if you do they are only like $2
Load them in the clip, pull slide back, put clip in. Or just read the instructions! XD
hit the tab at the back of the spent clip the old clip should fall out put a full clip back in and pull the tab on the side of the gun all the way back then let it go it shold snap back into place with a bullet in the chamber now its ready to shoot
I am not sure exactly but my mechanic put it back in for me in about 30 seconds.
well if your talking about the clip,you just put the dart in ,but when you put the second one push the first down then put the second one in then just keep doing that and thats how you put darts back in into the nerf recon cs6 by:jrock 54.
no different bumper and different back clip