how to install a distributor
How many hours to put in a distributor in a 4.3 s-10 2002?
No, you don't have to change to the new distributor if you don't want to.
Distributor timing is adjusted by rotating the distributor. A scan tool is required to put the engine computer in distributor sync mode. The distributor is then set to zero degrees.
To remove the distributor on your Chevy Celebrity 2.5L 4 cylinder engine: 1, Set the timing to the number one cylinder in the firing position. 2. Remove the distributor cap and put out of the way. If you take out any of the spark plug wires make note of where to put them back. 3. Loosen and remove the retainer clamp and its bolt. 4. Pull the distributor out of the block. To reinstall the distributor reverse the instructions. You will need to re-time the engine when you put the distributor back in.
Why do you want to put an OBD0 distributor in a OBD1 motor?
Not unless someone put a breaker point's distributor in it. It had an HEI / HIGH ENERGY IGNITION distributor in it from the factory.
Could damasge the distributor/hall sender leading to a starting fault.
'Dizzy' is a lazy way to put 'distributor'.
The distributor is off a tooth or two. You can pull the distributor out and turn the rotor a little and put it back in. Then re-time the engine.
Depends some distributors are vertical some horozontal put the plug end in with wires facing away from center of distributor
Yes you can no problem.