0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Replace belt on 2003 rav 4?
To change fan belt on a Rav 4, remove the bolt in front of the engine. Loosen the pulley and gently pull away the fan belt. Replace with new.?æ
Why has your fan stopped working?
a fuse could be blown if its electric or you may need a new fan check that its getting power before you replace it . and a belt driven fan the internal may be worn out you need a new pulley section
Installing fan belt on 1992 Chevy k1 blazer?
Put your new fan belt around the pulleys of your 1992 Chevy Blazer. Tighten the fan belt with the tensioner pulley.
How do you know you need new driving belts?
Squeaking or tearing of the rubber on the belt
How do you repair 1993 5.0 jeep Cherokee fan belt?
buy a new belt
How do you fix a fan belt on a 2001 Dodge Stratus?
Sorry, there isn't a fan belt on any front wheel drive vehicles since the engine sites transversely (side-to-side). If your fan isn't rotating then you likely need eaither the fan thermostatic switch or a new fan motor... Good Luck, br1ght
How do you adjust a Fiat doblo 1.9jtd fan belt?
HOW How do you FIT A NEW a fiat doblo 1.9jtd fan belt?Read more: How_do_you_adjust_a_fiat_doblo_1.9jtd_fan_belt
Fitting a new fan belt on vauxhall frontera?
Which engine?
How do you tighten the fan belt on a 1998 Chrysler Intrepid?
theres no way to tighten it you will have to buy a new belt
How do you install a new fan belt on a 1998 Ford F150?
The serpentine belt has a tensioner that you nust pry up to remove the belt. There should be a schematic of the routing of the belt on the fan shroud. If not, draw one before removing it.
How do you replace the water pump on a 1993 Chevy Cavalier?
Drain the radiator. Remove the fan and fan shroud if needed. Remove the pump belt. Unbolt the pump and remove it. Install the new pump. Reinstall the belt, fan and fan shroud. Refill the system with new coolant.
How do you change a serpentine belt on a 1999 Ford Ranger XLT?
You have to first remove the fan shroud, then the fan. Take a wrench or socket extention and connect to the tensioner pulley. Turn clockwise to losen the belt and slide it off. Installation is the reverse of removal. -------- You do not need to remove the fan shroud or fan. Check the diagram in the engine compartment that shows you the belt routing. Locate the tensioner pulley. Using a box wrench or socket wrench if it will fit, turn clockwise and pull the belt off as you get more slack. Work the belt around the fan and remove. Repeat the steps above to install the new belt.
