You are going to have to remove the fuel tank by disconnecting the hoses and wiring harness.Only then can you access the pump which goes in the top of the tank.
Remove the hoses from your 1978 Chevrolet 350 cubic inch engine fuel pump. Remove the fuel pump belt. Remove the fuel pump retaining bolts. Reverse the process to install the new fuel pump.
you have to drop the fuel tank, remove the hoses after it is lowered a bit. once completely removed open up the sending unit and pull out the fuel pump , replace and re-assemble
Put on new hoses.
Take the 2 clamps off each end of the fuel line and pull the rubber hoses off the fuel line along with the old filter, put new rubber hoses on new filter and make sure arrow on filter is pointing towards carburetor and install rubber hoses onto the fuel line on both ends and tighten clamps on both ends.
Mark and disconnect the hoses, undo the bolts and withdraw pump, spacer and gasket. Clean off old gasket and install in reverse order.
you need to disconnect the hoses above the fuel rails, remove the air instake hose, remove those filters on the hoses, remove the fuel lines off the fuel rails, pull the fuel rails up not sideways you may brake the injectors! the injectors do not screw on they just pop in and out of the fuel rail and engine block...pretty simple id be glad to do it for anyone free if your around elizabethtown ky, i have a ls400 1991 and i know these cars pretty well!
A fuel pump siphons the fuel through hoses.
get under the truck disconnect hoses unmounted old fuel pump...mount new pump reconnect hoses.
yes, if the fuel filter is clogged causing high back pressure on the fuel return it can pop off the injector fuel return lines [bypass hoses]
how do you install a fuel filter on an 04 kia Rio
As with any fuel filter you need to know where it's located. You can find this information on autozone.com for free for most vehicles. Then: 1. Relieve your fuel system pressure (run the engine, remove your gas cap and pull the fuse from the fuse box that runs your fuel pump and wait for your engine to die) 2. Remove any bolts and or hoses that connect to your fuel filter and mount it on your vehicle 3. Install the new fuel filter by re-connecting the hoses and bolts mounting the fuel filter. 4. replace your fuse, gas cap and start your engine