answersLogoWhite

0


Best Answer

same way you get the thing started, Sledgehammer!

User Avatar

Wiki User

17y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you get the calipers off a 2004 Dodge Durango?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What if your Dodge Durango 2004 head light on n off on n off?

then you need to stop flicking the light switch


How do you change brake pads and rotors on 2005 dodge durango with 4 wheel drive?

You will need to remove the tire and wheel from your 2005 Dodge Durango. Remove the brake pad Springs and calipers. Tap the rotors with a hammer to loosen them. Slide the rotors off. Reverse the process to install the new rotors and brake pads.


Where is the emergency fuel shut off inertia switch in a Dodge Durango?

A Dodge Durango does not have an inertia switch. The fuel system is computer controlled with relays.


Where is the cut off switch for the fuel pump in a 2003 dodge durango?

There is no inertia switch on a Dodge.


Is the overdrive light supposed to be on or off for a 2000 Dodge Durango?

off unless you are towing


Location of emergency shut off valve for 2002 dodge durango?

An emergency shut off is used in some vehicles to stop power to the fuel pump during an accident. The 2002 Dodge Durango does not have an emergency shut off.


How hard is it to replace brake calipers on a Jeep Liberty 2004?

Replacing the calipers are pretty simple. just take the wheel off and its right there. Two bolts and its off. Calipers are not something that usually has a problem.


Dodge Durango and it will stop running and start again?

when my 1998 Dodge Durango would start and cut back off, I had to reset the alarm by using the lock / unlock buttons on my key remote.


What steps do you take in taking rotors off a 2004 Dodge Dakota They are stuck?

If you have the calipers and brackets off, all you do is spray the hub with penetrating oil (wd40) and hit the rotor (between the studs) with a hammer. It will come loose eventually.


How do you turn off tire pressue light on 2004 dodge durango?

C'mon... someone out there must know how to do this... My light is on, too... and my local Dodge dealer is telling me I have to replace the whole console!!! If all of the tires are set properly, then you have a sensor or module failure.


Where is the factory amp located in a 2002 dodge durango?

THE FACTORY AMP IS LOCATED UNDER THE DASH BORD PASSENGER SIDE THERES ONE SREW THE PANEL COMES OFF AND THERE IS THE AMP 2001 DODGE DURANGO


Were is fuel pump cut off switch on 1999 durango?

Dodge does not use inertia/cut off switches.Dodge does not use inertia/cut off switches.