Open the hatch door. Right behind the license on the inside of the door is a cover that you take off using a thin blade. This exposes the back of the bulb holder and the wire connected to it. Remove the wire by pulling on the connector that fits into the back of the bulb holder. The back of the bulb holder then needs a quarter turn counter clockwise. The best tool to use to turn the bulb holder is a 15 mm socket on an extension long enough to reach the bulb holder inside the hatch. Once you have removed the bulb holder, you can simply pull the bulb straight out of the front of the bulb holder. Replace the bulb with a #168 bulb.
Change the bulb. It uses a "wedge style" bulb. Pop off the red plastic cover on the right side of the lens (may have already fallen off). Loosen screw and pull out assembly. Twist bulb holder about 90 degrees to separate lens and holder. Pull bulb staight out.
open the bonnet, locate the back of the bulb holder and rotate half a turn, pull the complete holder out to expose the bulb. change the bulb and reverse the process.
In the sedan you remove the bulb holder in the boot lid by twisting and pulling thn push the bulb down in the holder and twist then pull out
A hardware store.
you remove back cover to expose wires and connectors then turn h7 bulb holder anticlockwise then the holder and bulb pull out
Some do, some do not.
what is the position of the reversing bulb in the bulb holder
That bulb should be accessable from inside the trunk. Pull the carpet away from the area behind the bulb. There should be a screw out bulb holder. Just twist it and pull it and the bulb out. Replace the bulb and twist the bulb holder back into place. Re-seat the carpet.
There is a bulb holder below the headlight bulb holder on the right side.It is inside a hole big enough to get your hand in but it is in tight quarters. This holder I believe turns to the right. I used a flashlight to see where it was.
If you mean just the bulb, they are accessed from the trunk. Pull the carpet away from the back of the car and untwist the bulb holder. Replace the bulb and screw the holder back in.
yes