0
you have to take the wheel off first of all.Then you will see,bolted on to the axle,right over top the brake rotor is the brake caliper,fastened by two bolts that you remove,causing the whole caliper to come loose.next u will see two more bolts of close to the same size holding the brake slider in place.remove them.now u can remove the pads from the slider.before putting the new pads in the slider, take two c-clamps and push both plungers back as far as they go.now,put the new pads in place,bolt the slider onto the caliper,bolt the caliper to the axle mount,and put the wheel back on. Good Luck!! you have to take the wheel off first of all.Then you will see,bolted on to the axle,right over top the brake rotor is the brake caliper,fastened by two bolts that you remove,causing the whole caliper to come loose.next u will see two more bolts of close to the same size holding the brake slider in place.remove them.now u can remove the pads from the slider.before putting the new pads in the slider, take two c-clamps and push both plungers back as far as they go.now,put the new pads in place,bolt the slider onto the caliper,bolt the caliper to the axle mount,and put the wheel back on. Good Luck!!
Add your answer:
Earn +20 pts
How to change Front Brake Pads on 97 Chevy S10 Truck?
you pull off the front wheel, then you remove the break caliper, then replace the break pads,.., it helps if you have a large C-clamp..
What would cause a sort of rubbing noise like low brake pads on the rearend of a 1998 Chevy S10 after replacing both bearings?
Low brake pads, misassembled brake parts?
How do you adjust the emergency brake on your 2001 S10 Chevy?
How do you adjust the emergency brake on your 2001 S10 Chevy?
What size wrench do you need to change the brake pads on a 1994 s10?
3/8" allen wrench.
How do you find a brake switch wiring diagram for a 1997 Chevy S10?
where can i find a diagram for a 1997 chevy s10 brake switch?
What size allen wrench is required to change front brake pads on 2000 Chevrolet s10 truck?
3/8"
How to check front brake pads on Chevy s10 truck 1997 model?
Look at the pads and measure the thickness. The minimum allowed thickness for the brakes pads is 2 mm. Replace if they are worn to this point. You will have to remove the wheel to measure the pads.
Chevy s10 hydraulic brake system diagram?
where is the drake light switch on a 1999 chevy s10. The brake light switch is located just above the brake pedal. You will need a flashlight to see it.
How do you release a stuck parking brake on 1999 S10?
my parking brake release did not take off the parking brake on my 2001 chevy s10? is there a way to disengage it?
How do you change the front shocks on 2000 Chevy S10 pickup?
how to change front shocks in 01 Chevy s10
How do you change the third brake light on Chevy s10?
You didn't mention what year the S10 is but, you can probably remove the 2 small screws that hold the lens to the housing and you will have access to the bulbs.
What do you do if you have no emergency brake after replacing the rear pads and drums of a 2001 Chevy S10 4WD?
There are a number of things that you can have done wrong. Get a manual on your car from the parts store and it will tell you how it is supposed to work.
