0
Add your answer:
Earn +20 pts
How do you change 1999 ford explorer front brake rotors?
remove the brake caliper and the rotors come right off
How to change front rotors on a 1999 windstar?
You remove the wheels, remove the brake caliper and the rotor is then free .
How can you change bad brake rotors on a 1999 Plymouth Voyager?
You jack up and block the car. Remove wheel, remove brake caliper. Rotor is now free.
What causes a 1999 Chevrolet Malibu to shake only when brake is applied when in drive?
if you are driving and you go to stop, then that means that the front rotors are warped. if the front rotors are bad, you will feel a pulsation in pedal while applying brakes. change rotors on front.
Would the rotors from a 1999 Montana fit a 2007 Town and Country?
The brake rotors for the 1999 Montana and 2007 Town & Country are different part numbers and different dimensions; therefore they will not interchange.
Why does your 1999 grand am shakes when you brake stop?
What you're describing sounds like "disk brake chatter". It's a condition caused by warped rotors. Rotors often warp when they're old and/or have been overheated.
On your 1999 Ford F-150 the rear anti brake light stays on?
try replaceing brake pads, or check the rotors for damage
Your 1999 Ford Taurus steering wheel shudders sometimes when you brake it why?
Most likely warped rotors.
How to remove and replace front brake rotors on 1999 Nissan frontier?
how to remove front rotors on 2003 Nissan fronter 4 wheel drive pick up
What is the minimum thickness of the front brake rotors on a 1999 ford expedition?
Should be stamped on rotor Should be stamped on rotor
Why does your 2001 Jeep Grand Cherokee Laredo steering vibrate when you apply the brakes?
Warped brake rotors. This is a very common problem for the 1999-2004 Grand Cherokees. You will need to have your rotors replaced, or resurfaced. The best resurface method is with an on car brake lathe.
How do you change the front rotors on a 1999 Chrysler Cirrus?
You need to put the car on jacks and have a few tools handy, like a mallet and screwdriver. Do not let the brake pad clamp together! Hang them buy a wire.
