answersLogoWhite

0


Best Answer

The camshaft position sensor on a Mazda Miata is changed by disconnecting the wiring harness and unscrewing the sensor using a wrench. The threads can then be cleaned and a new sensor torqued into place.

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change the camshaft position sensor on a mazda miata?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the camshaft positioning sensor in 2003 Mazda Miata?

The 2003 Mazda camshaft position in sensor can be found on the back of the left-hand cylinder head. The camshaft position sensor should be labeled as such.


Where is the camshaft positioning sensor on a Mazda Millenia 2.5L DOHC?

Camshaft position sensor of Mazda Milenia 2,5L DOHC is inside ignition distributor (the same part with iggnition comutator).


Where is the camshaft position sensor on a Mazda Miata?

On a 1999-2005 model Mazda Miata the camshaft position sensor is located on the valve cover towards the rear of the engine (closest to the firewall). It has one 3-pin connector connected to it and one 10mm bolt to remove the sensor


Where is the camshaft position sensor on a 2003 Mazda B3000 3.0L pickup?

i just had mine replaced by a mechanic and he told me it was sitting on top of camshaft


Where is the camshaft position sensor on a 92 Mazda mx3?

It is located on the inside of the distributor . Three pin connector .


Where is the crankshaft sensor on a 1997 Mazda Protege?

Answerthe camshaft sensor is the distributor but the crankshaft position sensor is located right next to the crankshaft its held on by one bolt


Where is the knock sensor located on a 1999 Mazda Millenia 2.5 engine?

Most knock sensors are located in the block on the firewall side. Should be the only sensor with two wires in the block. It will also have a camshaft position sensor as well. Hope that helps. I am not educated on Mazda engines.


Where is the CPS located on 1993 Mazda miata?

Camshaft Position Sensor is on the back of the valve cover on the right side (if looking directly at the engine from the front of the car).


What is a code p1345 on a Mazda Protege?

it is a camshaft position sensor check vaccume lines also as for some reason this will throw this cone because of rough idle


Where is the camshaft sensor located on a 2000 Mazda 626?

It's part of the distributor


Where is the camshaft positioning sensor located on a Mazda b2500?

still waiting on a answer , is it the same as a 2.3?


Where is the crankshaft position sensor on a Mazda tribute 2004?

location cranckposition sensor mazda tribute 4cyl