Hey TammyIt is at the rear of the intake manifold and is that big shinny round thing. Remove the vac line then the 2 bolts that hold it on. Clean where it mounts and install the new one. GoodluckJoe
ACTUALLY IT DOES NOT HAVE A VACUUM LINE TO IT AND IS RIGHT BESIDE THE BIG AIR TUBE THAT GOES TO THE ENGINE. iT HAS A PLUG ON TOP OF IT WITH 4 OR 5 WIRES GOING INTO IT. TWO BOLTS HOLD IT ON tHEY ARE 10MM SOCKET BOLTS. vERY EASY TO CHANGE
Once off, usually you can just use some carb cleaner to make sure it is free and screw it back on so you don't have to buy a new one.
see saturnfans.com
where is the evap purge valve located in a 1996 jimmy
The bleeder valve is a 8mm bolt for the rears located on top of the drum or on the caliper itself if you have disk rear brakes. For the front, a 10mm bolt is located on the caliper itself. PB blaster should be used to be sure the bleeder valve is not broken
The EGR Valve on the 1996 Mitsubishi Galant is located underneath the Exhaust Manifold.
The water pump on a 1996 Saturn sl2 is located in the engine compartment. It sits below the AC compressor.
No
how do i remove the valve cover to change the gasket in a toyota camry 1996
I think the best way to find out is to go to the nearest Saturn dealer and ask the auto department where it is located. They won't charge you for location of part.
The PCV valve on a 1996 Ford Escort 1.9L is located between the engine and the radiator. It is near the vacuum hose.
A 1996 Ram does not have EGR
Located on the fuel rail drivers side
The thermostat is usually located on the lower hose, where it attaches to the radiator