0
Open the rear hatch door.
1. Remove the 4 screws holding the lens assembly to the vehicle. It may have a silicone or a sealer holding it in place, so if it does, slowly pull the assembly towards you as you cut away anything holding it in place after the screws are removed.
2. You can now remove the bulb assembly by holding firm the lamp assembly and twist counter clock wise the bulb socket then pulling straight out from the lamp assembly.
3. To remove the bulb socket from the lamp assembly, push in on the bulb, and twist it clockwise while pulling on it.
The bulb should now be removed.
4. Insert new bulb, twist clockwise to lock it into place.
5. Insert the bulb and socket assembly into the lens assembly and twist the socket clockwise to lock it.
6. Reinstall the lens assembly, then tighten lens assembly screws. Test lights.
Add your answer:
Earn +20 pts
How do you change the front brake pads on a 1993 Ford Aerostar 4.0?
Lift the car on a jack, remove the tire, remove the brake shoe/caliper and remove the old brake pad. Put in the new brake pad, replace the brake shoe/caliper, replace the tire and lower the car to the ground.
How do you change brake light switch on 93 Jeep Grand Cherokee?
The 1993 Jeep grand Cherokee brake light switch simply plugs in and out. The brake light switch is located beneath the dashboard on the drivers side of the engine compartment.
Why would your brake light be on 1993 Chevy Beretta?
Brake light switch defective or out of adjustment.
Why brake light stays on 1993 Chevy s10?
Defective or misadjusted, brake light switch.
How do you change the front pads on a 1993 Areostar?
You need to remove the front tires to change the front brake pads on a 1993 Aerostar. So the new pads fit, you need to squeeze the caliper back, and then tap out the slide rails. Remove the old pads and replace with new ones and reassemble.
How do you change the power window motor on the 1993 aerostar?
how do you change a window motor on a 93 aerostar or can you please tell me how to get the windows down without the motor... my e-mail is snakespittbulls@yahoo.com
What causes brake light to blink on dash in 1993 GMC Sierra 1500?
Worn brake pads can cause the brake light to blink on the dash in a 1993 GMC Sierra 1500. This can also be caused by a faulty light.
How do you get to spark plugs in order to change on 1993 ford aerostar and what equipment is required?
take off the wheel look right pass all the brake stuff you will be able to get to two of em that way and get 2 in front of the van
Picture of thermostat on a ford aerostar van-1993?
where is location of thermostat in ford aerostar van, 1993
Where is the brake light switch located on a 1993 Nissan Sentra?
The brake light switch is located above the brake pedal on a 1993 Nissan Sentra. To reach the switch the driver's door needs to be opened.
How do you remove rear brake lens on 1993 ford probe?
The 1993 Ford Probe rear brake light lens cannot be removed. The tail light are a complete seal light. The light bulb's can be removed from the rear of the light assembly.
Freon pressure for 1993 Aerostar with R-134a?
The 1993 Aerostar does not use R-134a. It uses R-12.
