There really is no adjustment you can make. If you do not have any clutch, you need to check the clutch slave cylinder reservoir. Driver side rear of compartment attached to the fire wall. If it is empty, refill it and then pump your clutch up, just like you are bleeding your brakes. Make sure you reinstall the cap before you start pumping. If it is empty there is a reason. Get it to a shop. There really is no adjustment you can make. If you do not have any clutch, you need to check the clutch slave cylinder reservoir. Driver side rear of compartment attached to the fire wall. If it is empty, refill it and then pump your clutch up, just like you are bleeding your brakes. Make sure you reinstall the cap before you start pumping. If it is empty there is a reason. Get it to a shop.
where is the horn relay on a 93 ranger
i called the ford dealership they recominded that u not do it yoursealf unless you had a full shop worth of equipment i have a 93 ford ranger 2.3L 5speed and i had it done by a local mechanic for 300 i bout the parts myself it was worth it..
the fuel pump is located inside the gas tank of my 93 ford ranger
The hydraulic clutch slave cylinder is located on the mainshaft of the trans. You must remove the trans to get to it
Dot 3
very carefully
Exterior panels: 93-97 Bed: 93+ Interior Panels: 95+ www.FordRanger.net
You can't adjust the clutch on ANY Escort. They have hydraulic clutches with a master cylinder and a slave cylinder. However, if the clutch isn't releasing it can be bled of air.
What is the fireing order plug 93 ford ranger xlt 3.0
For a 1993 Ford Ranger : ( DOT 3 brake fluid )
Here you will find all the seats that will bolt right into the ranger: www.therangerstation.com/tech_library/seats.html
First you need to make sure that all the air is bleed out of the slave cyinder. Then to adjust the point at which the clutch will engage, tighten or loosen the pushrod nut. It will be near the clutch pedal on a little rod between the firewall and pedal (the pushrod).