2003 Oldsmobile Alero Brake Light Bulb Troubleshooting (check in this order):
· Check Fuse(s)
· Check Brake Bulbs - Including bad bulbs, loose connected or incorrectly installed bulbs, left, right and center high mount - 1 bad bulb or connection in the circuit can cause the entire circuit to malfunction.
· Check Turn Signal Bulbs
· Check switch on brake pedal
· Check license plate light bulb and wiring (sometimes on same circuit)
· Check trailer hitch wiring harness (sometimes on same circuit)
· Check all wiring harnesses and wiring for shorts
Most likely it's the fuse or a burnt bulb breaking the circuit. Sometimes the license plate and/or the trailer hitch is wired into other circuits and can cause issues in other areas. Sometimes its wires grounding out somewhere on the vehicle. See sources and related links below for bulb information. See owner's manual for location and identification of fuses.
brake light on when driving oldsmobile alero
You can remove the ABS and brake light, from your Oldsmobile Alero, by removing the dash cover. The light retaining nut must be removed. The light will come out.
you either have a blown bulb or you have a broken wire
because there is a problem with your anti-lock brakes
There is a repair kit available to repair the grid. A test light will find the break in the grid.
Check the brake pedal switch. Check the bulbs. Check the grounds.
The brake light switch is located under the dash drivers side under a sound cover held in place by 2 screws, not that hard to remove.
what does the engine light on the 1999 olds alero mean
No, a wheel bearing should not set off a low tire pressure light in a 1999 Oldsmobile Alero.
my Oldsmobile alero did the same thing. It turned out to be as simple as a blown bulb in my tail light.
You could be low on brake fluid.
894 for Sylvania.