How do you change front tire studs on a 1994 Seville sts
Trim the wheel behind the studs
remove tire un bolt and hold the caliper out of the way the rotor just slides on the studs
wheel studs? head studs?
a nokian tire is 130 and a winterfores is 100
You can use the end of the tire iron to remove the lug bolts off a 1999 Mazda Protege DX.
They are metal Pins that are stamped into a tire and they help you get more grip on snow and ice. :D
The wheel studs are replaced by first removing the tire from the brake. Remove the disk brake pads and caliper if it is the front and remove the brake drum if it is the back. Once you have the brake disk or drum off, simply pound the studs with a heavy hammer and they will pop out the back. if you plan on reusing the studs put the nut on the threads so it is flush with the end and then use hammer as not to ruin threads. Spray WD-40 or heat the brake disk/drum(not the studs) if they are stubborn or rusty.
remove tire. remove brake by loosening two 17 mm nuts. punch in studs withhammer and drift. pull off rotor. anti-sieze helps aids future removal. weasel in studs and tighten with lugs. replace brake. remove lugs. budda bing budda boom done
To change the front wheel studs on a 1993 Chevy S10, you will need to remove the tire and brake caliper. If it is a floating rotor, you will need to remove the rotor. To install, you will need to use a special tool for removal. If the tool is not available, be prepared to use a large nut and washer for installation.
do you want to remove the actual studs or remove the lug nuts? the lug nuts may have left hand thread which means they go clockwise to loosen if you mean remove actual studs, u need to remove wheel. the studs will knock out with a hammer. you will need to replace with new ones
Remove the tire and the 2 keeper washers on the studs.There are 2-18? mm bolts on the inboard side. Remove them and slide the caliper off. The rotor should slide off the studs. HTH DON TX