I need the routing for the serpentine belt for 1990 Ford 150?
its under your hood with the firing order and distributor order
Do you mean a SCHEMATIC diagram?
I need a diagram for a serpentine belt for a 1994 f150 with 5.0 engine I need a diagram for a serpentine belt for a 1994 f150 with 5.0 engine There should be a sticker near radiator shroud that has belt routing. If not stick the belt down past the right side of fan/water pump .put belt on crank pulley then pull back of belt over water pump and then down around power steering pulley and up over compressor pulley. put belt from crank pulley around smog pulley then up to tensioner with back of belt around tensioner and then around alternator pulley.next put rachet and socket(15 mm) on tensioner and pull on it while placing belt under idler pulley.
Serpentine puller
the belt tensioner does it by itself.short answer no
Remove serpentine belt. Remove pulley. Install new pulley. Install serpentine belt.
yes,a good parts man will give you a belt to bypass your ac.
Serpentine Belt Under the hood should be a diagram of the belt, this is your best reference without the service manual. All you have to determine is which direction to rotate the belt tensioner, and then put the belt back on as shown in the diagram. If it is not you can run down to your nearest auto parts store and they can print it out for you or just buy the Hayes or chilton manual on your car. It only cost a few bucks and it well helps you out later down the line if something else brakes.
i can't access a diagram on the net BUT when you open your hood there should be a diagram right there in the very front near the grill. I said should be because sometimes they come off or some dummy will remove it.
The tension on a 1988 Ford F150 can be loosened by adjusting the belt tensioner. The retaining bolt is loosened, the tensioner shifted slightly, and tightened down.
the easyiest way to change it would be to buy the belt then take it to the ford dealer ship and have them put it on