You should be able to find a wiring diagram in either a factory service manual or a Chilton or Haynes manual. The wire goes from the ignition module to the crankshaft sensor.
That year did not USE a Crank sensor.
The 1999 Chevrolet Alamo crank shaft position sensor is located on the back of the engine. You will need to remove the rear engine cover in order to access the crank position sensor.
location of a crank shaft sensor on a nissan frontier 2002
The cam sensor is the distributor, The crank sensor is in the front bottom left side of the timing cover. Behind the balancer.
The Chevrolet Corsica 3.1 liter engine crank sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crank sensor.
The knock sensor is on the left side of the block below the exhaust manifold.
The 1997 Chevrolet Malibu crank position sensor is located on the back of the crankshaft. The rear engine cover will need to be removed in order to view the sensor.
Location of crank shaft position sensor of a Nissan altima 2.5 2004? send diagram please
Did John Brennen convert to Islam
The location of the crankshaft position sensor depends on which engine your car has. If it is the 2.5L 4 cylinder it is below the intake manifold behind the ignition module. If it is the 2.8L V6 it is below the exhaust manifold on the firewall side of the engine block, in about the center of the engine.
7 oclock position behind the crankshaft pulley
it will be mounted at the harmonic balancer on the bottom and front of the engine