One can do anything that they choose too. But referring to your actual question, if you pull it out it will shut off, wait actually if you pull off the spark plug wire to get to the plug the mower will already be shut off. no spark no fire. No go soldier. Plus if it was possible, you'd probably damage the engine in some way.
not secured properly, user sockets
how to replace plug wire on a toro mower
what is the spark plug setting for 7hp self prepelled troy bilt mower
Yes
what spark plug do i need for a 3.75
You pull the ruber boot off the top of the spark plug , take the plug out, put boot back on the plug, touch steel part of the plug to steel on motor,pull motor over while watching the gap on the plug if you see spark it should be ok if no spark do the same with a spark plug you know is good to make sure it is the plug. Hope this helps
Buy a plug wrench.
A good lawn mower spark plug will have just a small amount of brown deposit. In addition, the gap will be very close.
In order to change the spark plug wires in a Toro lawn mower, the engine housing should be removed. The spark plug wire will then be disconnected which is a simple twisting movement under pressure. This is a very quick procedure.
To check a coil you just need to take out your spark plug but leave it plugged into the coil and ground the spark plug while trying to turn it over. If it is a good strong spark than your coil is fine. If it doesn't spark than unplug the wire going to it and try it again if it doesn't spark than it is a good chance your coil is bad. if it does spark than it is a wire problem. Also make sure that your spark plug is gaped correctly, usually at about 0.030.
I own a John Deere 1458 mower and it takes an NGK plug #BPR5ES.
Would you use lawn mower plugs in your car?? NO!!!!