answersLogoWhite

0


Best Answer

Yes, but to be done properly it requires an expensive kit from Dodge/Mercedes.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Can you install two batteries in a dodge sprinter?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How many oxygen sensors in a 2007 dodge sprinter?

Two.Two.


Does 2000 dodge ram 2500 diesel have two batteries?

It was built with two batteries, yes.


Why does a dodge charger have two batteries?

It doesn't...


Does the dodge charger have two batteries?

No, just one and it is in the trunk.


Why does a 1994 Dodge Ram diesel have two batteries?

Most diesels have 2 batteries to supply the necessary cold cranking amps Two little batteries are cheaper then one big battery


Why is there two batteries on the Dodge Magnum?

The question assumes there are 2 batteries, when in reality there are not 2 batteries. It has only one and it is located in the trunk near the spare tire.


Are there two air filters for a 2008 dodge sprinter diesel?

One engine air filter and one cabin air filter.


How you remove radio from dodge sprinter 2005?

There are two special tools that look like keys that are inserted to release locking tabs


How do you remove the radio on a 2003 to 2006 Dodge Sprinter?

There are two special tools that look like keys that are inserted to release locking tabs.


Fuse panel location 2005 Dodge Sprinter Van?

There are two, one is in the steering column, the other one is under the driver seat.


How long to replace the water pump on a 2002 2.7?

Chrysler V6, six to eight hours. Mercedes/Dodge Sprinter, two to three hours.


How to change the batteries in a dodge diesel truck?

Get new batteries first, your local parts store will help with that, they might even install them for free! If not just open the hood use a 1/2 inch wrench to loosen the battery cables ( Two cables on both batteries) Remove the cables undo the hold down plate and trade batteries, tighten the hold down plate and the cables, make sure the red cables are on the + side and the black ones are on the - side.