Connect the AUDIO INPUT of the Sound system to the AUDIO OUTPUT of the TV set. Connect the Cable Box to the #1 VIDEO input on the TV. Connect the BLUE RAY to the #2 VIDEO input of the TV set. The TV might have a AUDIO OUTPUT function in the AUDIO MENU. switch this to FIXED. This will send a even audio signal to your sound system at all times. Turn the TV sound down and use the sound system speakers.
Connect the audio out of the TV to the audio input of the surround receiver with a dual RCA cable. Note that this connection isn't surround. You will need to connect a DVD, Blu-Ray or digital cable box to the surround receiver for true surround sound.
An HDMI cable connects from the Bell cable box to the surround receiver and then to the TV.
It is possible that the signal coming from the source is corrupted. Digital cable and sattelite boxes sometimes have sound dropouts that cannot be fixed on your end.
The KLV32ex400 has no surround output capability. The only audio output is a stereo 1/8" headphone jack. If you are using a Blu-Ray or HD cable or satellite receiver, you can run an optical or coaxial digital cable from those directly to the receiver for surround sound.Read more: Need_to_connect_Sony_Bravia_klv32ex400_which_has_no_clear_audio-out_port_to_5.1_channel_surround_without_hdmi_so_where_do_you_connect_the_5_cables_from_the_surround_sound_system_to_the_HDTV
An optical audio cable is used to transmit digital audio (AC-3) signal from the source to the receiver, such as from a DVD player to a digital audio amplifier/receiver. You can transmit 5.1 dolby digital or DTS surround sound with an optical audio cable, same as digital coaxial audio cable.
If your receiver has an HDMI input, use that. If it doesn't, then you will have to use analog or digital audio connectors to plug it in.
The direct answer to this would be, no. But I think you might be asking the wrong question. To get surround sound to play your television programs you would need to put your cable/satellite box through the receiver. As a side note: There are two ways to do this. 1. If you receiver supports video pass thru (which would mean that there are VIDEO IN jacks and VIDEO OUT jacks) If not then proceed to the next option. You will hook up everything from the cable/satellite box to the receiver and just one cable, which will be the video signal, to the television. 2. You will hook up only the audio cables to the receiver and a single video cable straight to the television.
You can use the built-in speakers to project the center channel of a 5.1 or 7.1 surround system, but you will find much better sound using an external center channel speaker above or below the middle of the screen. The digital output of a modern LG plasma screen can be sent to a surround sound receiver, but you must listening to a surround sound source, either a digital TV channel using the built-in tuner, a digital cable or satellite receiver or a DVD or Blu-Ray player.
Digital optical audio cable can carry data to decoder-enabled devices in a few formats; Dolby DTS is one of many such formats. Some of these can carry surround sound. Besides, optical is digital, and standard sound card output is analog.
Connect the sound system to the AUDIO OUTPUT connectors on the back of your TV. If theses connectors are not there you will need to get a new TV with these connectors or if there is a cable or Satt. box, connect the surround to these.
A Dolby Digital stream from a DVD player can be sent to a high def receiver by digital optical or coaxial cable.
The KLV32ex400 has no surround output capability. The only audio output is a stereo 1/8" headphone jack. If you are using a Blu-Ray or HD cable or satellite receiver, you can run an optical or coaxial digital cable from those directly to the receiver for surround sound.