mixer main out TO behringer feedback destroyer input TO speakers
Yes you can connect it out of AUX send. infact that is the best place to connect it from
I have connected 4 to that mixer and it was too much. You will most likely take out the amp. if you connect 6. Two is about all it can handle.
You connect the mixers main outputs to the inputs of the amplifier and the outputs of the amplifier to speakers
If the TV has an audio output, connect this to a stereo amplifier, and then connect speakers to this. Modern TV's don't have amplifiers for external speakers.
Absolutely, the key is to make sure you are really using an unpowered mixer and that the signal level is correct for the power speakers (usually XLR will do fine).
Just use it like an 8 ohm speaker or else connect two 16 ohm speakers in parallel to form an 8 ohm load. Parallel is positive to positive and negative to negative.
In most cases you need 4 parts: 1- Input(microphone, iPod, CD player, radio, etc) 2- Mixer 3-amplifier 4- speakers
1202vlz is just a mixer, so you either need active speakers or passive speakers with separate amplifiers
I am buying the new dj how dou connect with speekers
I would just connect it to the mixer without reducing it to 3/8".
You need to connect the DVD player and speakers to an amplifier.